Bow Ring out of Duct Tape

Powered by Instructables.

Step 1: Bow Ring Out Of Duct Tape

you will need:
a bit o' duct tape
a ruler or something like that
scissors/ x-acto knife/ sharp edged thing


Step 2:

Cut yourself a decent size of duct tape (about 3 inches [eyeball it]) then clip the ends just a bit so it looks clean and even. Measure your clean strip from one end 2 inches then SNIP!





Step 3:

Doodle (if you want) on your 2 in. strip


Step 4:

Turn your strip over, if you doodled, to the plain side. Scrunch a little of the top to the inside then pinch it to the middle. Do the same to the bottom.



Step 5:

Cut a slim strip, the length of the width of duct tape, and wrap it around the middle of the bow to keep it scrunched.



Step 6:

Now cut a 4 inch long strip of duct tape about 1/2 inch in width. Fold it in half, this will be the band.




Step 7:

Align the middle of the bow to the middle of the band and tape them together with a skinny strip of tape the length of the width of duct tape.


Step 8:

Put the band on your finger bow side up. Size the flaps to your finger and mark where they end. Tape them with a tiny piece of tape down.




Step 9: Final Step

Check Durability, fix mistakes, spruce it up + you're done:)



License: Attribution-NonCommercial-ShareAlike.

Tools and Space
Age Level
Category
Time Per Project